Lantronix SLC 8000 User Manual

13: Maintenance
SLC™ 8000 Advanced Console Manager User Guide 278
Administrative Commands
These commands for the command line interface correspond to the web page entries described
above.
To immediately terminate all connections and reboot the SLC 8000 advanced console
manager:
admin reboot
Note: The front panel LCD displays the "Rebooting the SLC" message, and the normal
boot sequence occurs.
To prepare the SLC 8000 advanced console manager to be powered off:
admin shutdown
Note: When you use this command to shut down the SLC unit, the LCD front panel
displays "Shutting down the SLC," followed by a pause, and then "Shutdown complete."
When "Shutdown complete" displays, it is safe to power off the SLC 8000 advanced
console manager.
To list current hardware and firmware information:
admin version
To update SLC firmware to a new revision:
Note: For updates via FTP, TFTP or SFTP, the firmware file should be accessible via
the settings displayed by admin ftp show. The SLC 8000 advanced console manager
automatically reboots after successful update.
admin firmware update <ftp|tftp|sftp|nfs|usb|sdcard> file <Firmware
File> key <Checksum Key> [nfsdir <NFS Mounted Directory>][usbport
<U1|U2>]
To list the current firmware revision:
admin firmware show [viewlog <enable|disable>]
Lists the current firmware revision and optionally displays the log containing details about
firmware updates.
To clear the firmware update log:
admin firmware clearlog
To configure parameters that control how the SLC boots and when it switches to the
alternate boot bank:
admin firmware bootcount <0|1>
admin firmware bootlimit <3-20>
admin firmware bootdelay <3-1800>

Lantronix SLC 8000 Specifications

General

Rack mounting	Yes
Console port	RJ-45
Serial ports quantity	48
USB 2.0 ports quantity	2
AC input voltage	120-230 V
Power source type	AC
AC input frequency	50 - 60 Hz

Weight and Dimensions

Weight	5030 g
Dimensions (WxDxH)	436.9 x 304.8 x 43.18 mm