Lantronix SLC 8000 User Manual

12: User Authentication
SLC™ 8000 Advanced Console Manager User Guide 220
User Rights
The SLC has three user groups: Administrators, Power Users, and Default Users. Each has a
predefined set of rights; users inherit rights from the user group to which they belong. These rights
are in addition to the current functions that a user can perform at the command line interface:
 connect direct/listen
 set locallog/password/history/cli
 show datetime/deviceport/locallog/portstatus/portcounters/
 history/cli/user
The table below shows the mapping of groups and user rights.
Table 12-2 User Types and Rights
You cannot deny a user rights defined for the group, but you can add or remove all other rights at
any time.
By default, the system assigns new users to the Default Users group, but you can change their
group membership at any time. If you change a user's rights while the user is logged into the web
or CLI, the results do not take effect until the next time the user logs in.
User Right Administrator Power Users Default Users
Full Administrative Rights
X
Networking
XX
Services
X
Date/Time
XX
Local Users
X
Remote Authentication
X
SSH Keys
X
User Menus
X
Device Port Operations
X
Device Port Configuration
X
USB
X
Reboot/Shutdown
XX
Firmware/Configuration
X
Diagnostics and Reports
XX
Secure Lantronix Network
X
Web Access
XX
Internal Modem
X
RPMs
X
SD Card
X

Lantronix SLC 8000 Specifications

General

Rack mounting	Yes
Console port	RJ-45
Serial ports quantity	48
USB 2.0 ports quantity	2
AC input voltage	120-230 V
Power source type	AC
AC input frequency	50 - 60 Hz

Weight and Dimensions

Weight	5030 g
Dimensions (WxDxH)	436.9 x 304.8 x 43.18 mm