Lantronix SLC 8000 User Manual

15: Command Reference
SLC™ 8000 Advanced Console Manager User Guide 352
Description
Displays information on the internal memory, storage and processes of the SLC 8000 advanced
console manager. You can optionally email the displayed information.
diag lookup
Syntax
diag lookup <Name> [email <Email Address>]
Description
Resolves a host name into an IP address. You can optionally email the displayed information.
diag loopback
Syntax
diag loopback <Device Port Number or Name>[<parameters>]
Parameters
test <internal|external>
xferdatasize <Size In Kbytes to Transfer>
Defaults: test=external, xferdatasize=1K
Description
Tests a device port by transmitting data out the port and verifying that it is received correctly.
A special loopback cable comes with the SLC 8000 advanced console manager. To test a device
port, plug the cable into the device port and run this command. The command sends the specified
Kbytes to the device port and reports success or failure. The test is performed at 9600 baud. Only
an external test requires a loopback cable. The External test is currently not supported for USB
device ports.
diag netstat
Syntax
diag netstat [protocol <all|tcp|udp>] [email <Email Address>]
Defaults: protocol=all
Description
To display a report of network connections. You can optionally email the displayed information.
diag nettrace
Syntax
diag nettrace <one or more parameters>

Lantronix SLC 8000 Specifications

General

Rack mounting	Yes
Console port	RJ-45
Serial ports quantity	48
USB 2.0 ports quantity	2
AC input voltage	120-230 V
Power source type	AC
AC input frequency	50 - 60 Hz

Weight and Dimensions

Weight	5030 g
Dimensions (WxDxH)	436.9 x 304.8 x 43.18 mm