Image Optimization 5-91
Operation
Rotate the knob under [Filter] on the touchpad.
The higher the level is, the smaller the noise of the elasto image becomes, and the
clearer the edge of the field target appears.
The system restarts scanning B image and E image after the filtering is completed.
Map Position
Description
This feature is used to adjust the up/down position of the map.
Tap [Map Position] on the touch screen to adjust the parameter.
Lesion
Description
It is used to distinguish elastography data of the different lesion region.
Operations
Tap [Lesion] on the touch screen to adjust.
E Avg
Description
Used to optimize the measurement result via equalizing the elasto metric of the current
frames and the previous frames.
Operation
Rotate [E Avg] knob to adjust the value.
The adjusting range is: 2-10.
Off represents the E Avg is disabled. The larger the scale is, the more the frames of the
elasto metric are equalized.
Decrease the image noise.
E bar
This feature supports the elasto curve to be displayed based on different statistical
amounts.
Tap [E bar] on the touch screen to adjust the parameter.
Save All
Used to send all current elasto curve data to the relevant exam report.
Tap [Save All] on the touch screen to send the data.
5.13.2.3 Measuring
Press <Caliper> to enter general measurements. You can perform the measurements of Elastography,
Elas. Ratio, Directional Ratio, Elas. Hist and etc.
Press <Measure> to enter application measurement. You can perform measurements on Isthmus and
Mass, etc.
Refer to Operator’s Manual (Advanced Volume) for details.
5.13.2.4 Cine Review
Press <Freeze> to freeze the image and enter cine review state.
To Next Page
Loading...
Need help?
General
