Image Optimization 5-97
Selection Description
Function that turns the screen graphic text “On” or “Off.” The function is the same as
the Labels on/off icon at the top of the screen.
Information includes: name of level, name of view, heart rate, time stamp acquisition,
timers, frame slider, loop ID, clip control. For the cine without distributed view, the
name of level and name of view are displayed in “--”.
Apply edit all Clip edit applied to all clips taken.
Clip Length Specify the clip segments: systole, diastole, full cycle or user-defined.
For continuous acquisition, when the bookmark is set to “On”, only the selected loops
for the current view can be displayed.
Delete
Unselected
Delete clips that are not selected. If selected, the system will delete all clips that are
not selected after the exam is ended.
Suspend exam Pauses the stress echo exam but does not end the stress echo exam.
When a stress echo exam is suspended, the user can perform image acquisition of
all other imaging modes, or perform operations such as measurement.
End the stress echo exam.
5.14.4 Review/WMS Mode
Review/WMS mode is used by cardiologists to evaluate clips for cardiac wall motion abnormalities.
Different views from different stages are selected for comparison across a wide variety of combinations.
The most common workflow is to compare “same views” but at “different stages” of the exam (e.g.,
PSLA view, Rest stage compared to PSLA view, Post-exercise stage).
5.14.4.1 Enter review mode
Select [Review/WMS] on the menu on the left side of the screen.
1. Select [Shuffle Mode] on the touch screen.
2. Select the label of the phase or view (for example, Rest or Long Axis) on the right part of the screen.
The system displays all loops that represent the selected phase or view.
To display phases for the selected view(s)
1. To include a phase or view for display, select the leftmost, gray box to the left of each required phase
and/or view.
The system inserts a checkmark into each selected gray box.
2. To exclude a phase or view from display, select the blue box to the left of each required phase and/or
view.
To Next Page
Loading...
General
