Probes and Biopsy 13-25
Note: the above needle-guided brackets whose name starts with NGB are reusable. The CIVCO
brackets are disposable.
13.2.2 Basic Procedures for Biopsy Guiding
1. Select the correct needle-guided bracket and needle and install them properly. For details, see
“13.2.3 Needle-Guided Bracket Inspection and Installation.”
2. Verify the biopsy guide line.
3. Press <F11 Biopsy> on the keyboard or touch [Biopsy] on the touch screen to enter the biopsy.
Tip:
If the current probe has no corresponding bracket, or the image is frozen and the guide
line was hidden before the image was frozen, then you cannot enter the Biopsy menu.
Before entering the Biopsy menu, the system will display the prompt “Please calibrate
guidelines before biopsy!.”
4. Use touch screen controls to select the bracket and guide line according to the actual situation.
5. In the Biopsy menu, touch [Verify] to enter the Verify menu to verify the guide line. After
verification, click [Save] to save the parameter setting. Then click [Exit] to return to the Biopsy
status.
Tip:
If you changed the probe or needle-guided bracket during the biopsy, verify the guide line
again.
When exiting the Verify menu without saving, the system will display the prompt “Are you
sure to save data changes?” Click [Yes] to save the setting and return to the Biopsy status.
6. Scan to locate the target. Center the target in the electronic guidezone path.
7. Direct the needle into the area of interest for specimen.
8. After extracting the biopsy sample is complete, gently remove the probe from the body.
To exit Biopsy: press <F11 Biopsy>.
9. Disassemble the items and properly dispose of these items as required.
To Next Page
Loading...
Need help?
General
