3-6 System Preparation
3.2.6 Standby
When the batteries are charged to full capacity, the system's standby time is no less than 24 hours.
To enter standby:
Open [Setup] → [System] → “General” to set the time for screensaver and standby. If the
system is not carrying out an operation, the screensaver appears after the screensaver delay
period. If there is still no operation, the system enters standby after the standby delay period.
Press the power button and select “Standby”, the system enters standby mode.
To exit standby:
Press the power button.
Under the standby status:
Press the power button to exit standby status and then power off the system.
If the system will not be used for a long period of time, you should disconnect the power
adapter, disconnect the mains power, and turn off the power to all peripherals
To Next Page
Loading...
Need help?
General
