10-22 Patient Data Management
2. Select a user, click [Edit Privilege] to enter the "Edit user privilege" dialog box, and select or
deselect the check box from the privilege list.
3. Click [OK] to confirm the editing and exit the dialog box. The edited privileges will appear in the
User List.
Modifying Passwords
The system administrator can modify all user passwords. The administrator password is empty by
factory default. You can set this password.
An operator can only modify his/her own password. There are two ways to modify passwords: on
the “Access Control” page or in the “Session Manage” dialog box.
“Access Control” page (administrators can modify the password)
1. Open the “Access Control” page using the path: [Setup] → [System] → [Access Control”].
2. Select the user name to be modified in User List. Click [Change Password] to open the dialog
box.
3. Enter both the previous and new passwords, and confirm the new password in the dialog box.
4. Click [OK] to exit.
Session Manage page (general operators and administrators can modify the password).
When the user has logged onto the system,
is visible in the bottom-right corner of the
screen.
1. Click
in the bottom-right corner to bring up the Session Manage dialog box where you can
see the current user’s information.
2. If you want to modify the current password, click [Change Password] to bring up the Change
Password dialog box.
3. Enter both the previous and new passwords, and confirm the new password in the dialog box.
To Next Page
Loading...
Need help?
General
