Safety
1-5
2004 Nordson Corporation
A1EN−01−[XX−SAFE]−10
Installation Practices
Install the equipment in accordance with the instructions provided in this
document and in the documentation provided with auxiliary devices.
Ensure that the equipment is rated for the environment in which it will be
used and that the processing characteristics of the material will not
create a hazardous environment. Refer to the Material Safety Data
Sheet (MSDS) for the material.
If the required installation configuration does not match the installation
instructions, contact your Nordson representative for assistance.
Position the equipment for safe operation. Observe the requirements for
clearance between the equipment and other objects.
Install lockable power disconnects to isolate the equipment and all
independently powered auxiliary devices from their power sources.
Properly ground all equipment. Contact your local building code
enforcement agency for specific requirements.
Ensure that fuses of the correct type and rating are installed in fused
equipment.
Contact the authority having jurisdiction to determine the requirement for
installation permits or inspections.
Operating Practices
Familiarize yourself with the location and operation of all safety devices
and indicators.
Confirm that the equipment, including all safety devices (guards,
interlocks, etc.), is in good working order and that the required
environmental conditions exist.
Use the personal protective equipment (PPE) specified for each task.
Refer to Equipment Safety Information or the material manufacturer’s
instructions and MSDS for PPE requirements.
Do not use equipment that is malfunctioning or shows signs of a
potential malfunction.
To Next Page
Loading...
Need help?
General
