Operation
4-18
P/N 7105144G
2008 Nordson Corporation
VersaBlue_NW
Filling the Tank
CAUTION: Cease operation before the tank is completely empty. If there is
too little material in the tank, the material can overheat. Overheated material
can char, collect on surfaces and cause malfunctioning.
NOTE: For melters with inert gas equipment (option): Before filling the tank,
ensure that the inert gas inlet hole is not blocked with material.
Manually
WARNING: Hot! Risk of burns. Wear appropriate protective
clothing/equipment. Tank and tank lid are hot. When filling, hot material may
splash out of the tank. Use caution when filling tank with material.
CAUTION: Do not operate melter with open tank. When the tank is open,
hot material vapors can escape; vapors may contain potentially hazardous
substances.
CAUTION: Before filling the tank, ensure that the tank and material are
clean and free of foreign substances. Foreign substances can hinder
functioning or even cause damage to the melter or accessories.
Fig. 4-8
To Next Page
Loading...
Need help?
General
