Installation
3-2
P/N 7105144G
2008 Nordson Corporation
VersaBlue_NW
Lifting (Unpacked Melter)
Refer to the section Technical Data for weight. Lift melter only at the chassis
using suitable lifting equipment or a forklift.
Installation Requirements
Set up only in an environment that corresponds to the stated Degree of
Protection (Refer to section Technical Data). Do not mount in a potentially
explosive atmosphere! Protect from vibration.
CAUTION: Protect the control panel from direct sunlight. The UV rays
reduce the lifetime of the liquid crystals.
Melters with Transformer
The transformer is located under the melter.
Keep cables and hoses out of the space under the melter.
Position the unit such that air can circulate sufficiently under the melter.
Exhausting Material Vapors
Ensure that material vapors do not exceed the prescribed limits. Always
observe the safety data sheet (MSDS) for the material to be processed. If
necessary, exhaust material vapors and provide sufficient ventilation of the
location of the system.
Fig. 3-3
To Next Page
Loading...
Need help?
General
