• If Auto Continue occurs on the first set, Collate will be canceled.
• If forced printing occurs on the first set, Collate will be canceled.
• When setting Collate in the printer driver settings, make sure that a collate option is not selected in
the application's print settings. If a collate option is selected, printing will not be as intended.
• For details about printing method, see the printer driver Help.
Spool Printing
With Spool Printing, the print data is saved in the hard disk before printing. To use this function, set it from
the menu. See "Remote Maintenance by telnet".
• To use this function, the optional hard disk must be installed on the printer.
• Use the "spoolsw clear job" telnet command to clear a spooled print job. Do not turn off the printer
or computer while a print job is being spooled and the Data In is flashing. Print jobs that are interrupted
in this way remain on the printer's hard disk and will finish printing out when the printer is turned back
on.
• The Spool Printing function is available for data received using diprint, lpr, ipp, ftp, and sftp (TCP/IP
(IPv6)).
• When using diprint, the Spool Printing function cannot be used with bidirectional communication.
• The domain reserved for spool printing is about 1 GB.
• When Spool Printing is on, the size of a single print job cannot exceed 500 MB.
• When receiving jobs from multiple computers, the printer can spool a maximum of ten lpr jobs, and
only one diprint, ipp, ftp, sftp, or smb job. If the printer's spooling capacity is exceeded, newer jobs
cannot be printed. You must wait before sending further jobs.
• Printing the first page with Spool Printing will be slow.
• The computer requires less print processing time when large amounts of data are spooled.
• Stored spool jobs can be viewed or deleted using Web Image Monitor.
• The list of spool jobs cannot be viewed from the printer's control panel.
Advanced Printing
75
To Next Page
Loading...
Need help?
General
