If "on" is selected, IPv6 requests information required for maintaining stateful connection to the router
for as long as the printer power is turned on. This setting allows information from the router to be
obtained constantly, and periodically refreshes the effective period of the stateless address.
lpr
Use the “lpr” command to view and configure LPR settings.
View setting
msh> lpr
Checking host name when deleting the job
msh> lpr chkhost {on|off}
If “on” is selected, you can delete print jobs only from the IP address of the host that sent the print job.
If LPR is disabled, you can also delete print jobs sent from IP addresses other than that of the host.
Printer Error Detection Function
lpr prnerrchk {on|off}
If you set this to “on”, the printer stops receiving data and will wait until the error is resolved before
continuing processing a job.
netware
Use the "netware" command to configure the NetWare settings such as the print server name or file server
name.
Netware printer server names
msh> netware pname "character string"
• Enter the NetWare print server name using up to 47 characters.
Netware file server names
msh> netware fname
• Enter the NetWare file server name using up to 47 characters.
Encap type
msh> netware encap {802.3|802.2|snap|ethernet2|auto}
Remote printer number
msh> netware rnum {0-254}
Timeout
msh> netware timeout {3-255}
Remote Maintenance by telnet
235
To Next Page
Loading...
Need help?
General
