spoolsw
Use the "spoolsw" command to view and configure Job Spool settings.
You can only specify diprint, lpr, ipp, ftp, smb and sftp protocol.
• The "spoolsw" command for configuring Job Spool settings is available only when the optional hard
disk is installed.
View settings
The Job Spool setting appears.
msh> spoolsw
Job Spool setting
msh> spoolsw spool {on | off}
• Specify "on" to enable Job Spool, or "off" to disable it.
Resetting Job spool setting
msh> spoolsw clear job {on | off}
• When the printer power is cut during job spooling, this determines whether to reprint the spooled
job.
Protocol configuration
msh> spoolsw diprint {on | off}
msh> spoolsw lpr {on | off}
msh> spoolsw ipp {on | off}
msh> spoolsw smb {on | off}
msh> spoolsw ftp {on | off}
msh> spoolsw sftp {on|off}
• You can specify the settings for diprint, lpr, ipp, smb and sftp.
msh> spoolsw wsprn {on|off}
ssdp
Use the "ssdp" command to view and configure SSDP settings.
View settings
msh> ssdp
Setting effective time
msh> ssdp profile {1801-86400}
5. Monitoring and Configuring the Printer
248
To Next Page
Loading...
Need help?
General
