Getting Printer Information over the Network
This section explains details of each item displayed in the printer status and information.
Current Printer Status
The printer status can be checked using the following commands:
• UNIX: Use the "lpq" command and "rsh", "rcp", "ftp" and "sftp" parameters.
• mshell: Use the "status" command.
Messages Description
Adjusting... The printer is initializing or calibrating.
Call Service Center There is a malfunction in the printer.
Canceling Job... The job is being reset.
Configuring... Setting is being changed.
Cooling Down Fusing Unit... Fusing unit is cooling down.
Cover Open: Duplex Unit The cover of the duplex unit is open.
Cover Open: Exit/Rear Cover The exit/rear cover is open.
Current Job Suspended Current jobs are suspended.
Empty: Black Toner The black toner cartridge is almost empty.
Energy Saver Mode The printer is in Energy Saver Mode.
Error: DIMM Value A memory error occurred.
Error: Ethernet Board An Ethernet board error has occurred.
Error: HDD Board A hard disk drive board error has occurred.
Error: Optional Font An error has occurred in the font file of the printer.
Error: Optional RAM An error has occurred in the SDRAM module.
Error: Parallel I/F Board An error has occurred in the parallel interface.
Error: PDL An error has occurred in the page description
language.
Getting Printer Information over the Network
259
To Next Page
Loading...
Need help?
General
