5. Press the [ ] or [ ] key to select the lead time needed to switch to the Energy Saver mode.
6. Press the [ Enter] key.
Wait two seconds. The [Energy Saver] screen appears.
7. Press the [Menu] key.
The initial screen appears.
System Menu parameters
This section explains about parameters that can be set on the System menu.
Prt. Err Report
You can select [On] or [Off] to have an error report printed when a printer error or memory error
occurs.
• Off
• On
• Default: Off
Auto Continue
You can make the Auto Continue setting. When set to on, printing continues after a system error occurs.
• Off
• Immediate
• 1 minute
• 5 minutes
• 10 minutes
• 15 minutes
• Default: Off
• If you set [Auto Continue] to On, a job might be cancelled if an error occurs while it is printing
out. When a job is cancelled due to error, the printer automatically begins the next job in the
queue.
4. Making Printer Settings Using the Control Panel
150
To Next Page
Loading...
Need help?
General
