5. Press the [Menu] key.
The initial screen appears.
PS Menu Parameters
This section explains about parameters that can be set on the PS menu.
Job Timeout
You can specify how long the printer waits (in seconds) before cancelling the current job when the
job is interrupted while being processed.
• Driver/Command
• Machine Setting
• Default: Driver/Command
• If you select Machine Setting, enter a value between 0 and 999. (Default: 0)
Wait Timeout
You can specify how long the printer waits (in seconds) before it cancels receiving the job when the
printer cannot detect the end of the job.
• Driver/Command
• Machine Setting
• Default: Driver/Command
• If you select Machine Setting, enter a value between 0 and 999. (Default: 300)
Data Format
You can select the data format.
• Binary Data
• TBCP
This setting is effective when using a parallel, USB, or EtherTalk connection.
When you use a parallel or USB connection, the print job is canceled if binary data is sent from
the printer driver.
When you use an Ethernet connection, the print job is canceled if:
• The printer driver data format is TBCP and the data format selected using the control panel
is Binary Data.
• The printer driver data format is binary and the data format selected using the control panel
is TBCP.
PS Menu
171
To Next Page
Loading...
Need help?
General
