• Be sure to specify the interface.
• wlan can be specified only when the wireless LAN interface unit is installed.
Interface name Interface configured
ether Ethernet interface
wlan Wireless LAN interface
Address configuration
Use the following command to configure a WINS server IP address:
msh> wins "interface_name" {primary|secondary} "IP address"
• Use the "primary" command to configure a primary WINS server IPv4 address.
• Use the "secondary" command to configure a secondary WINS server IPv4 address.
• Do not use "255.255.255.255" as the IPv4 address.
NBT (NetBIOS over TCP/IP) Scope ID Selection
You can specify the NBT scope ID.
msh> wins "interface_name" scope "scope ID"
• The scope ID can be entered using up to 31 alphanumeric characters.
• Be sure to specify the interface.
• wlan can be specified only when the wireless LAN interface unit is installed.
Interface name Interface configured
ether Ethernet interface
wlan Wireless LAN interface
wsmfp
Use the "wsmfp" command to view and configure WSD (Device) and WSD (Printer) settings.
View settings
msh> wsmfp
Comment settings
msh> wsmfp comments “comment”
• If you do not specify a comment, current setting is displayed.
Location configuration
mah> wsmfp location “location”
5. Monitoring and Configuring the Printer
256
To Next Page
Loading...
Need help?
General
