SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
xi
Important information
Purpose of this manual
The SIMOCODE pro system manual describes in detail the motor
management system and its functions. It contains information about
configuring, commissioning, service and maintenance. The user is
introduced to the system quickly and practically using a typical reversing
starter application as an example.
In addition to providing assistance for troubleshooting and fault elimination,
this manual also contains information of special importance to service and
maintenance personnel.
To assist in configuration, this manual also contains circuit diagrams,
dimension drawings and technical data of system components.
Required basic knowledge
To understand this manual you will require basic knowledge of low-voltage
controls and distribution, digital circuit engineering and automation
technology.
To p i c s
This manual consists of instructional chapters for reference purposes. The
following table lists the most relevant topics. Topics with a gray background
correspond largely with the contents of the "SIMOCODE ES"
parameterization and service software:
Topic Target group
System description Configurators, planners
Short instructions for commissioning a
reversing starter
Configurators, planners, technicians,
commissioners
Motor protection Configurators, commissioners
Motor control Configurators, PLC programmers
Monitoring functions Configurators, programmers,
commissioners, service personnel
Outputs Configurators, planners, programmers
Inputs Configurators, planners, programmers
Analog value recording Configurators, programmers,
commissioners, service personnel
3UF50 compatibility mode Configurators, PLC programmers
Standard functions Configurators, programmers
Logic modules Configurators, programmers
Communication Configurators, PLC programmers
Mounting, wiring, interfaces Mechanics, electricians, maintenance and
service personnel
Commissioning and servicing Commissioners, electricians, maintenance
and service personnel
Alarm, faults and system events Commissioners, maintenance and service
personnel, configurators, PLC
programmers
To Next Page
Loading...
Need help?
General
