Commissioning and service
SIMOCODE pro
14-14 GWA 4NEB 631 6050-22 DS 03
14.3.4 Resetting the factory settings
With the factory settings, all parameters are reset to the factory values.
Resetting the factory settings with the Test/Reset button on the basic unit
Proceed as follows (also deletes any previous password setting!):
Table 14-13: Resetting factory settings with the Test/Reset button on the basic unit
Notice
If any one of the steps is not carried out correctly, the basic unit will revert
to normal operation.
Notice
This function is always active, independent of the "Test/Reset - Button
blocked" parameter.
Resetting the factory settings with the SIMOCODE ES software
Prerequisite: SIMOCODE pro is connected to the PC/programming device
via PROFIBUS DP or via the system interface and SIMOCODE ES is started.
Proceed as follows (resets to factory settings, excluding the password):
Table 14-14: Resetting the factory settings with the SIMOCODE ES software
Step Description
1 Switch off the supply voltage for the basic unit.
2 Press the Test/Reset button on the basic unit and keep it pressed.
3 Switch on the supply voltage for the basic unit. The Device LED lights up
yellow.
4 Release the Test/Reset button after approx. two seconds.
5 Press the Test/Reset button again after approx. two seconds.
6 Release the Test/Reset button after approx. two seconds.
7 Press the Test/Reset button again after approx. two seconds.
9 Factory settings are reset.
Step Description
1 Click on the menu Switchgear > Open Online.
2 In the menu, select Target System > Command > Factory Settings.
3 Confirm with "Yes".
4 Factory settings are reset.
To Next Page
Loading...
Need help?
General
