Short instructions for configuring a reversing starter
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
2-3
2.2 Reversing starter with motor feeder and local control
station
Necessary components
The following table lists the components required for this example:
Item Ordering data Order number
1 Basic unit SIMOCODE pro C
(SIMOCODE pro V also possible)
3UF7000-1AU00-0
(3UF7010-1AU00-0)
2 Current measuring module 0.3 A up to 3 A 3UF7100-1AA00-0
3 Connecting cable for connecting the basic unit to
the current measuring module, depending on
length
3UF793.-1AA00-0
4 "SIMOCODE ES 2007 Basic" software for
parameterization via the system interface
or
"SIMOCODE ES 2007 Standard" software for
parameterization via the system interface
or
"SIMOCODE ES 2007 Premium" software for
parameterization via PROFIBUS DP and the system
interface with the graphic editor, includes STEP 7
Object Manager
3ZS1 312-4CC10-0YA5
3ZS1 312-5CC10-0YA5,
3ZS1 312-5CC10-0YD5,
3ZS1 312-5CC10-0YE5,
3ZS1 312-6CC10-0YA5,
3ZS1 312-6CC10-0YD5,
3ZS1 312-6CC10-0YE5
5 PC cable for connecting the basic unit to a PC/
programming device
3UF7940-0AA00-0
Table 2-1: Components required for this example
To Next Page
Loading...
Need help?
General
