Inputs
SIMOCODE pro
7-14 GWA 4NEB 631 6050-22 DS 03
7.6 Analog module inputs
Description
SIMOCODE pro has an "AM Inputs" function block with two analog sockets,
corresponding to the two analog inputs of the analog module. The effective
analog value of each input can be read from these sockets and processed
internally. An additional binary socket of the function block represents the
status of the analog measuring circuits. The analog values can be processed
internally and/or transmitted cyclically to the automation system via the
"Cyclic Send" function blocks.
Note
The "AM Inputs" function block can only be used if the respective analog
module (AM) has been connected and configured in the device
configuration!
Schematic
The following schematic shows the "AM Inputs" function block:
Fig. 7-10: Schematic of the "AM Inputs" function block
Open circuit
AM Inputs
IN1+
30
31
33
34
Inputs:
IN2+
IN1-
IN2-
Input 1
Input 2
Event
Input signal
Response at
Open circuit
Active inputs
Terminal
numbers
Range:
0 ... 27648
To Next Page
Loading...
Need help?
General
