Mounting, wiring, interfaces
SIMOCODE pro
13-4 GWA 4NEB 631 6050-22 DS 03
13.2 Mounting
13.2.1 Basic units, expansion modules and the decoupling module
You can attach these system components as follows:
• Snap-on mounting onto a 35 mm standard mounting rail, without tools
• Snap-on mounting of the basic units onto current measuring modules of
45 mm and 55 mm width (up to 100 A) with integrated standard mounting rail
without tools
• Screw attachment with mounting lugs (Order no: 3RP1903) and screws for
mounting on a level surface.
These mounting lugs are only suitable for basic units, expansion modules and
the decoupling module!
Fig. 13-1: Mounting of basic units, expansion modules and the decoupling module
SIMOCODE pro C SIMOCODE pro V
with increased installation
Snap-on mounting onto standard mounting rails
Screw attachment
3RP1903
Ø 5 mm
Expansion module,
Ø 5 mm
3RP1903
Snap-on mounting onto a current measuring module
e.g. a 45 mm wide current measuring module with BU1
BU1 BU2
decoupling module
SIMOCODE pro V
DM-F,
DM-DO
depth
To Next Page
Loading...
Need help?
General
