TB8100 Service Manual Reciter Board Replacement 103
© Tait Electronics Limited September 2006
5 Reciter Board Replacement
Important This equipment contains devices which are susceptible to
damage from static charges. Refer to “ESD Precautions”
on page 17 for more information on antistatic procedures
when handling these devices.
This chapter provides information on how to remove and replace the system
interface board.
Note Unless otherwise noted, for the sake of simplicity and clarity, the
instructions and illustrations in this chapter refer to a UHF
(H-band) reciter fitted with an isolated system interface board.
However, the same basic procedures and techniques apply to other
models of reciter and system interface board.
To Next Page
Loading...
Need help?
General
