TB8100 Service Manual Reciter Fault Finding 75
© Tait Electronics Limited September 2006
3.4 Board Replacement
Replacing Faulty
Boards
At certain stages during the fault finding procedure, you will be instructed
to replace the system interface board. In these cases, go to “Reciter Board
Replacement” on page 103 and carry out the board replacement procedures
described there. The full procedure will normally involve:
■ removing the faulty board
■ fitting a new board
■ carrying out the specified reprogramming and recalibration tasks
using the Calibration Kit
■ carrying out the procedures described in “Final Tasks” on
page 95.
Refer to “Reciter Spare Parts” on page 109 for a full description of the
spares available for the reciter.
Disposing of Faulty
Boards
We recommend that you dispose of faulty boards according to your local
environmental and safety regulations. Otherwise, return them to your
nearest CSO for appropriate disposal.
To Next Page
Loading...
Need help?
General
