To Next Page

To Previous Page

Figure 15: USB bus setup with SuperSpeed selected.

To use

■

To change the input for a component, click the Input and select a channel from the cascading lists.

■

To change the voltage threshold level, click the Threshold (H) or Threshold (L) entry box and use the keypad to enter a

value or use the multipurpose knobs to select a voltage level.

■

To set the speed, click the Speed entry box and select from the drop-down list.

■

To set the signal type, click the Signal Type (not available with SuperSpeed) entry box and select from the drop-down list.

Behavior

The instrument changes the components, voltage threshold levels, speed, and signal type, and uses those to decode the

selected USB bus.

What do you want to do next?

Learn more about bus setups.

Learn about bus configuration.

Learn about digital setups.

Learn how to set up an I2C serial bus.

Learn how to set up an SPI serial bus.

Learn how to set up a USB serial bus.

Learn how to set up an RS-232 serial bus.

Learn how to set up a MIPI DSI1 Serial Bus

Learn how to set up a MIPI CSI2 Serial Bus

Learn how to set up an 8B10B Serial Bus

Learn how to set up a CAN Bus

Learn how to set up a MIL-1553 Bus

Learn how to set up an Ethernet Bus

Learn how to set up an Custom serial bus.

Learn how to troubleshoot a serial bus.

Learn how to track down serial bus anomalies.

Learn how to view analog characteristics of a digital waveform.

Bus setups

DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series 119

Tektronix DPO7054C Printable Help

Other manuals for Tektronix DPO7054C