Select a miscellaneous measurement
From the Measure menu, select Measurement Setup; then open the More tab.
To use
Use the More tab to select measurements not found under any of the other measurement tabs.
1. Select a source with the Channels Selector.
2. Click a Measurements button to add a More measurement to the Measure list:
More measurements
Area Cyc Area
Phase Burst Width
3. Click Display On in the upper-right corner of the Measurement Setup Control Window to turn the measurement display on
and off.
Behavior
Measurements are updated approximately three times a second, or less for long record lengths. Measurements are calculated
after each acquisition. You can display up to eight automatic measurements.
A new control window opens when you click Phase. Enter the parameters for the phase measurement, and then click Ok to
return to the Measurement Setup control window. The phase measurement is added to the list.
TIP. Select the individual measurements directly from the Measure menu More submenu.
What do you want to do next?
Learn about taking automatic phase measurements.
Learn about taking amplitude measurements.
Learn about taking timing measurements.
Learn about taking histogram measurements.
Learn about communications measurements.
Learn more about the Measurements list
Learn more about the Measurement controls.
Measurement setups
284 DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series
To Next Page
Loading...
Need help?
General
