Measurement setups
Measurement snapshot control window
From the Measure menu, select Measurement Snapshot.
Overview
Measurement Snapshot lists all of the automated measurements that are available for a selected waveform.
To use
1. Select the waveform for which you want to take a snapshot.
2. Click the Snapshot button in the Measurement control window, or select Snapshot from the Measure menu.
3. Click either General or Comm in the Snapshot Type group box to begin the snapshot.
Behavior
When the instrument has completed all of the measurements, the snapshot window is updated with the measurements.
Measurement Snapshot executes all of the single waveform measurements once; the measurements are not continuously
updated. Any measurements previously taken are retained on the display until you complete a new snapshot. To take another
snapshot, click the Refresh button.
NOTE. Automatic measurements are not available on digital channels.
TIP. Before taking a snapshot, be sure to properly display the waveform. Measurement Snapshot does not warn you if a
waveform is improperly scaled (for example, clipped, low signal amplitude, low resolution, and so on).
To change the source for taking a snapshot, select another channel, math, or reference memory waveform and then execute
snapshot again.
DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series 269
To Next Page
Loading...
Need help?
General
