Multipurpose knobs
The multipurpose knobs can be used to set screen interface parameters (Using the knobs on DPO70000SX instruments requires
the DPO7AFP accessory). To use, click a control on the screen to map it to the multipurpose knob(s).
Control Description
For MSO/DPO5000B Series instruments:
You can undo any mapping by right-clicking the multipurpose
knob(s) and selecting Deassign Multipurpose Knobs, or from
the Utilities menu, select the Deassign Multipurpose Knobs
command. The mapping is deassigned until you perform that
function again.
Turn the knob(s) or scroll with the mouse wheel until the
desired selection appears in the readout mapped to the knob.
Push the FINE button, or click the mouse wheel to use the
knob to make small changes, for example, to add another
decimal place for greater accuracy.
When no control windows are open and cursors are turned on,
the multipurpose knobs control the cursor positions.
NOTE. These knobs are automatically mapped when certain functions are performed, for example, when the MultiView Zoom
button is pushed.
Utilities
558 DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series
To Next Page
Loading...
Need help?
General
