Behavior
For Auxiliary Output, the selected signal is routed to the Aux Out BNC connector so that you can trigger another instrument, such
as a logic analyzer. The output voltage is TTL-compatible.
For External Reference Sources, the clock reference is routed to the Ext Ref BNC connector when you select External.
NOTE. You must perform a signal path compensation whenever you change the reference. When not using the external
reference, disconnect signals from the EXT REF IN BNC connector.
Touch screen
From the Utilities menu, highlight Touch Screen; then select Calibrate.
Overview
Use the Touch Screen submenu to calibrate the touch screen.
To use
1. Select Calibrate.
2. Follow the on-screen instructions.
Behavior
The Calibrate command starts the Touch Screen calibration program.
Instrument calibration control window
From the Utilities menu, select Instrument Calibration.
Overview
Use the Instrument Calibration control window to run the Signal Path Compensation (SPC).
The following screen appears on DPO70000SX instruments in a multi-instrument configuration:
Utilities
552 DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series
To Next Page
Loading...
Need help?
General
