202 Faxing
• Prefix Dial
NOTE:
• Prefix Dial only supports the environment where you send a fax to the external line number. To use Prefix Dial, you
must do the following from the operator panel.
1 Press the (System) button.
2 Select the Tools tab, and then select Admin Settings.
3 Select Fax Settings.
4 Select Fax Line Settings.
5 Select Line Type.
6 Select PBX.
7 Access the Fax Settings menu by following steps from 1 to 3.
8 Select Transmission Defaults.
9 Select Prefix Dial.
10 Select On, and then select OK.
11 Enter an up-to-five-digit prefix number from 0 – 9, *, and #, and then select OK.
12 Reboot the printer by turning the power switch off and then on.
Send Header Prints the sender's information on the header of faxes.
Select Off to turn this feature off.
Select On to turn this feature on.
For information on the region setting, see "Setting Your Region" on page 174.
ECM You can set whether to enable or disable the ECM (Error Correction Mode).
Modem Speed You can set the modem speed.
Display Manual Fax Recipients To set whether to display the fax number of the recipient when manually
sending a fax.
Fax Reports Fax Activity You can set whether to automatically print a fax activity report after every 50
incoming and outgoing fax communications.
Fax Transmit You can set whether to print a transmission result after a fax transmission.
Fax Broadcast You can set whether to print a transmission result after a fax broadcast to
multiple locations.
Option Description
To Next Page
Loading...
Need help?
General
