Troubleshooting 285
Auger Mark
NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji Xerox local
representative office or an authorized dealer.
Problem Action
The printed result has auger mark. The toner cartridges may be low or need to be replaced. Confirm the amount of
toner in each toner cartridge.
1 Check the toner level in the Status tab in the Printer Status window of the
SimpleMonitor.
2 Replace the toner cartridges as necessary.
Start Clean Developer.
1 Launch the Printer Setting Utility, and click Clean Developer on the Diagnosis
tab.
2 Click Start.
To Next Page
Loading...
Need help?
General
