Troubleshooting 315
Non-Genuine Mode
When toner within a toner cartridge is empty, XXXX Cartridge is Close to Life or Replace XXXX
Cartridge (XXXX: Yellow, Magenta, Cyan, or Black) appears.
When you want to use the printer in the Non-Genuine mode, enable the Non-Genuine mode and replace the toner
cartridge.
IMPORTANT:
• If you use the printer in the Non-Genuine mode, the performance of the printer may not be at its optimum. Any problems that
may arise from the use of the Non-Genuine mode are not covered by our quality guarantee. The continuous use of the Non-
Genuine mode can also cause the printer to break down, and any repair charges for such break down will be incurred by
users.
NOTE:
• To disable the Non-Genuine mode, select Off for Non-Genuine Toner on the operator panel or deselect the check box
next to On on the Non-Genuine Toner page on the Printer Maintenance tab in the Printer Setting Utility.
Using the Operator Panel
NOTE:
• Before starting the operation described below, confirm that the top service menu screen is displayed on the touch panel.
1 Press the (System) button.
2 Select the Tools tab.
3 Select Admin Settings.
4 Select Maintenance.
5 Select Non-Genuine Toner.
6 Select On, and then select OK.
The printer switches to the Non-Genuine mode.
Using the Printer Setting Utility (Windows Only)
The following procedure uses Windows 7 as an example.
1 Click Start All Programs Fuji Xerox Fuji Xerox Printer Software for Asia-Pacific your printer
Printer Setting Utility.
NOTE:
• The window to select a printer appears in this step when multiple print drivers are installed on your computer. In this
case, click the name of the desired printer listed in Printer Name.
The Printer Setting Utility opens.
2 Click the Printer Maintenance tab.
3 Select Non-Genuine Toner from the list at the left side of the page.
The Non-Genuine Toner page is displayed.
4 Select the check box next to On, and then click Apply New Settings.
To Next Page
Loading...
Need help?
General
