Fuji Xerox DocuPrint CM225FW User Manual

Using the Operator Panel Menus and Keypad 235
• Initialize NVM
Purpose:
To initialize NVM for system parameters, Address Book data for fax, or Address Book data for e-mail and server
address. After executing this function and rebooting the printer, the menu parameters or data, except the parameters
for the network, are reset to their factory default values.
See also:
• "Resetting to Factory Defaults" on page 256
Values:
• Non-Genuine Toner
Purpose:
To use toner cartridges of another manufacturer.
NOTE:
• Using a non-Fuji Xerox toner cartridge may severely damage your printer. The warranty does not cover damages caused by
using non-Fuji Xerox toner cartridges.
Values:
• Adjust Altitude
Purpose:
To specify the altitude of the location where the printer is installed.
The discharge phenomenon for charging the photo conductor varies with barometric pressure. Adjustments are
performed by specifying the altitude of the location where the printer is being used.
NOTE:
• An incorrect altitude adjustment setting leads to problems such as poor printing quality and incorrect indication of remaining
toner.
Values:
• Clear Job History
Purpose:
To clear the job history of all finished jobs.
Values:
• Adjust Touchscreen
Purpose:
To calibrate the touch panel.
User Fax Section Initialize Initializes the fax number entries in the Address Book.
User Scan Section Initialize Initializes the e-mail and server address entries in the Address Book.
System Section Initialize Initializes the system parameters.
Off* Does not use toner cartridges of another manufacturer.
On Uses toner cartridges of another manufacturer.
0m* Specifies the altitude of the location where the printer is installed.
1000m
2000m
3000m
Start Clears the log of all finished print job.

Fuji Xerox DocuPrint CM225FW Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CM225FW
Category	Printer
Language	English