om 5184516-100 Rev. 5 8-9
1-8-1 Key Switch on OTS Console
The Key Switch is located on the back of the OTS User Interface. The Key Switch
is intended for use when a system failure has occurred.
The OVERRIDE position disables the exposure hold interlocks and allows expo-
sure.
ILLUSTRATION 8-7
OTS CONSOLE KEY SWITCH
SECTION 2
AUTOMATIC COLLIMATOR
Operational Controls on the Collimator
NORMAL POSITION
OVERRIDE POSITION
KEY SWITCH
LABEL:
For X-Ray Field
Limitation System
Faliure
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
