EasyManuals Logo
Home>GE>Measuring Instruments>Precision 500D

GE Precision 500D User Manual

GE Precision 500D
323 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #307 background imageLoading...
Page #307 background image
om 5184516-100 Rev. 5 B-12
On the console, clean the frame and the mylar surface with a lint–free cloth moist-
ened with alcohol. DO NOT:
1. Use alkaline products.
2. Place objects on the mylar surface which are likely to cause scratches.
3. Use the console to write on.
NOTE: Be sure to follow the label instructions and pre–cautions for use, storage, and
disposal of all disinfecting agents.
4-2 HHS Testing (US Only)
The United States Department of Health and Human Services (HHS) has estab-
lished performance requirements for diagnostic x–ray equipment. These require-
ments are defined in Title 21 of the Code of Federal Regulations (21 CFR), and
apply only to certain specified components identified as “certified equipment.”
The manufacturer of specified diagnostic x–ray components must certify that the
components:
1. Perform as required by the HHS standard when installed, adjusted, and
tested as specified in the manufacturer’s instructions to the assembler.
2. Will continue to comply when maintained in accordance with the manufac-
turer’s instructions.
4-3 Recycling
Packing Materials:
The materials used to pack our equipment are recyclable. They must be collected
and processed in accordance with the regulations in force for the country where
the machines or accessories are unpacked.
Machines or Accessories at end–of–life:
The elimination of machines and accessories must be in accordance with national
regulations for waste processing. All materials and components that could pose a
risk to the environment must be removed from the machines at end–of–life and
accessories (examples: dry and wet cell batteries, transformer oil, etc.).
Please consult your local GEMS representative before discarding these products.
IN THE EVENT OF EQUIPMENT CONTACTING BROKEN SKIN OR
BEING USED WITH INFECTED OR IMMUNE COMPROMISED
PATIENTS, THE EQUIPMENT SHOULD BE CLEANED USING FDA
CLEARED AND EPA REGISTERED HIGH–LEVEL DISINFECTING
AGENTS. CIDEX LIQUID CHEMICAL GERMICIDE IS RECOMMENDED
FOR THIS PURPOSE.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE Precision 500D and is the answer not in the manual?

GE Precision 500D Specifications

General IconGeneral
BrandGE
ModelPrecision 500D
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals