GE Precision 500D User Manual

om 5184516-100 Rev. 5 2-24
5-10Patient Step
The patient step (ILLUSTRATION 2-2) provides patient convenience getting on
and off the table. The step is attached to the underside of the table body to the
right of the front support. Table angulation is prevented when the step is pulled
out. The white button must be pressed to push the step in.
ILLUSTRATION 2-2
PATIENT STEP
5-11Foot Rest
The foot rest is engaged on the table top in the same manner as shown for the
shoulder rest on ILLUSTRATION 2-3, and is designed to support a 300 lb (136 kg)
patient.
To attach:
1. Push on the safety latches with the thumbs and spread the handles.
2. Place the foot rest on the top adjacent to a set of slots and release the han-
dles.
3. Slide the foot rest until both handles snap into place.
INJURY COULD OCCUR IF PATIENT STEP IS NOT FULLY OUT.
VERIFY PATIENT STEP IS FULLY ENGAGED AND ASSIST THE
PATIENT ON AND OFF THE TABLE.
TO PREVENT IMPROPER ATTACHMENT AND POTENTIAL INJURY TO
PATIENT, USE THIS FOOTREST ONLY ON THE TABLE FOR WHICH IT
HAS BEEN ADJUSTED.
Installing the foot rest at the set of slots closest to the end of the
tabletop provides easier patient boarding.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).

GE Precision 500D Specifications

General

Brand	GE
Model	Precision 500D
Category	Measuring Instruments
Language	English