EasyManuals Logo
Home>GE>Measuring Instruments>Precision 500D

GE Precision 500D User Manual

GE Precision 500D
323 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #306 background imageLoading...
Page #306 background image
om 5184516-100 Rev. 5 B-11
3-1 Periodic Maintenance Schedule
SECTION 4
SERVICE
4-1 User Cleaning and Disinfecting
This equipment should be cleaned frequently, particularly if corroding chemicals
are present. Use a cloth moistened in warm soapy water (use mild soap) to clean
the trim and nameplate of the Operator’s Controls. Wipe with a cloth moistened in
clean water.
Do not use cleaners or solvents of any kind as they may dull the finish or blur the
lettering. Polish with a pure liquid or paste wax. Other surfaces of the equipment
can be cleaned using a clean cloth moistened slightly with a good mild cleaner
and polish acceptable for use on enamelled metal surfaces.
Before each use, equipment surfaces that contact the patient should be cleaned
with an EPA registered, low–level disinfecting or sanitizing agent.
MAINTENANCE ITEM FREQUENCY (MONTHS)
SAFETY
Check all counterweight cables 6 months
Check mounting bolts 6 months
Check ground leakage 6 months
Check loose or damaged hardware and accessories
6
months
FUNCTIONAL
Inspect components 6 months
Vacuum dust filters in cabinets, console, system control, & digital 6 months
Clean and lubricate 6 months
Check system operation 6 months
Check drives and locks 6 months
Check Indicators and interlocks 6 months
PERFORMANCE
Calibrate conversion factor compensation 6 months
mR/mAs Calibration 6 months
Check half value layer 6 months
Evaluate image quality (QAP) 6 months
Verify collimator response 6 months
Check photo timer (AEC) 6 months
Check protection circuits 6 months
Review previous performance 6 months
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE Precision 500D and is the answer not in the manual?

GE Precision 500D Specifications

General IconGeneral
BrandGE
ModelPrecision 500D
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals