GE Precision 500D User Manual

om 5184516-100 Rev. 5 B-10
SECTION 3
GENERAL
In order to assure continued safe performance of this x–ray equipment, a periodic
maintenance program must be established. Functional Checks will not indicate
that this x–ray system is performing to specifications. Only regular periodic main-
tenance can locate potential problems. It is the owner’s responsibility to arrange
for this service.
Inspection intervals are based on average daily use of one eight hour shift. More
frequent inspection is appropriate where equipment use is above average.
Aside from routine maintenance, any abnormal noise, vibration or unusual perfor-
mance should be reported immediately to a GE Medical Systems representative.
Before calling for service, however, be sure the equipment is being operated in
accordance with the foregoing instructions.
FAILURE TO PERFORM THE PERIODIC INSPECTION AND
MAINTENANCE COULD ALLOW DETERIORATING CONDITIONS TO
DEVELOP WITHOUT BEING DETECTED. THIS DETERIORATION
COULD RESULT IN EQUIPMENT FAILURES WHICH COULD CAUSE
SERIOUS INJURY OR EQUIPMENT DAMAGE.
ELECTRIC SHOCK HAZARD! THE OTS SUSPENSION CONTAINS NO
USER SERVICEABLE COMPONENTS. DO NOT ATTEMPT TO DISABLE
THESE COMPONENTS OR REMOVE ANY TRIM COVERS. REFER
SERVICE TO QUALIFIED PERSONNEL.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).

GE Precision 500D Specifications

General

Brand	GE
Model	Precision 500D
Category	Measuring Instruments
Language	English