124
Examples
# Set the global C-RP-Adv interval to 30 seconds in the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] c-rp advertisement-interval 30
# Set the global C-RP-Adv interval to 30 seconds in VPN instance mvpn.
<Sysname> system-view
[Sysname] pim vpn-instance mvpn
[Sysname-pim-mvpn] c-rp advertisement-interval 30
c-rp holdtime (PIM view)
Syntax
c-rp holdtime interval
undo c-rp holdtime
View
Public network PIM view, VPN instance PIM view
Default level
2: System level
Parameters
interval: C-RP timeout in seconds, with an effective range of 1 to 65,535.
Description
Use c-rp holdtime to configure the global C-RP timeout time, namely, the length of time that the BSR waits
before it must receive a C-RP-Adv message.
Use undo c-rp holdtime to restore the default.
By default, the C-RP timeout time is 150 seconds.
Because a non-BSR router refreshes its C-RP timeout time through BSR bootstrap messages, to prevent loss
of C-RP information in BSR bootstrap messages, be sure that the C-RP timeout time is not smaller than the
interval at which the BSR sends bootstrap messages. The recommended C-RP timeout setting is 2.5 times
the BS period or longer.
Related commands: c-bsr interval and c-rp.
Examples
# Set the global C-RP timeout time to 200 seconds in the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] c-rp holdtime 200
# Set the global C-RP timeout time to 200 seconds in VPN instance mvpn.
<Sysname> system-view
[Sysname] pim vpn-instance mvpn
[Sysname-pim-mvpn] c-rp holdtime 200
To Next Page
Loading...
Need help?
General