355
c-bsr holdtime (IPv6 PIM view)
Syntax
c-bsr holdtime interval
undo c-bsr holdtime
View
IPv6 PIM view
Default level
2: System level
Parameters
interval: BS timeout in seconds, in the range of 1 to 2,147,483,647.
Description
Use c-bsr holdtime to configure the BS timeout, namely, the length of time that the C-BSRs wait for a
bootstrap message from the BSR.
Use undo c-bsr holdtime to restore the default.
By default, the BS timeout value is determined by this formula: BS timeout = BS period × 2 + 10.
The default BS period is 60 seconds, so the default BS timeout is 60 × 2 + 10 = 130 (seconds).
Related commands: c-bsr and c-bsr interval.
Examples
# Set the BS timeout to 150 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] c-bsr holdtime 150
c-bsr interval (IPv6 PIM view)
Syntax
c-bsr interval interval
undo c-bsr interval
View
IPv6 PIM view
Default level
2: System level
Parameters
interval: BS period in seconds, with an effective range of 10 to 2,147,483,647.
Description
Use c-bsr interval to configure the BS period, namely, the interval at which the BSR sends bootstrap
messages.
Use undo c-bsr interval to restore the default.
To Next Page
Loading...
Need help?
General