12
View
User profile view
Default level
2: System level
Parameters
acl-number: Specifies a basic or advanced ACL number, in the range of 2000 to 3999. The source
address or address range specified in the advanced ACL matches the multicast source address or
addresses specified in IGMPv3 reports, rather than the source addresses of the IP packets. The system
assumes that an IGMPv1 or IGMPv2 report or an IGMPv3 IS_EX and TO_EX report that does not carry
a multicast source address carries a multicast source address of 0.0.0.0.
all: Specifies all ACLs.
Description
Use igmp-snooping access-policy to configure a multicast user control policy.
Use undo igmp-snooping access-policy to remove the configuration.
By default, no user control policy is configured. Namely, a user can join any valid multicast group.
You can use this command repeatedly to configure multiple multicast user control policies.
Examples
# Create and enable a user profile named abc t o a l l o w u s e r s t o j o i n 2 25 .1.1.1 o n l y.
<Sysname> system-view
[Sysname] acl number 2001
[Sysname-acl-basic-2001] rule permit source 225.1.1.1 0
[Sysname-acl-basic-2001] quit
[Sysname] user-profile abc
[Sysname-user-profile-abc] igmp-snooping access-policy 2001
[Sysname-user-profile-abc] quit
[Sysname] user-profile abc enable
igmp-snooping dot1p-priority
Syntax
igmp-snooping dot1p-priority priority-number
undo igmp-snooping dot1p-priority
View
VLAN view
Default level
2: System level
Parameters
priority-number: Specifies an 802.1p precedence for IGMP messages, in the range of 0 to 7. A higher
number indicates a higher precedence.
Description
Use igmp-snooping dot1p-priority to set the 802.1p precedence for the IGMP messages in a VLAN.
To Next Page
Loading...
Need help?
General