34
max-response-time (IGMP-snooping view)
Syntax
max-response-time interval
undo max-response-time
View
IGMP-snooping view
Default level
2: System level
Parameters
interval: Specifies the maximum response delay for IGMP general queries in seconds. The value ranges
from 1 to 25.
Description
Use max-response-time to set the maximum response delay for IGMP general queries globally.
Use undo max-response-time to restore the default.
This command takes effect only in IGMP snooping-enabled VLANs.
Related commands: igmp-snooping max-response-time and igmp-snooping query-interval.
Examples
# Set the maximum response delay for IGMP general queries globally to 5 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] max-response-time 5
overflow-replace (IGMP-snooping view)
Syntax
overflow-replace [ vlan vlan-list ]
undo overflow-replace [ vlan vlan-list ]
View
IGMP-snooping view
Default level
2: System level
Parameters
vlan vlan-list: Specifies one or multiple VLANs. You can provide up to 10 VLAN lists. For each list, you
can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The value range of a VLAN
ID is 1 to 4094. If you do not specify any VLAN, the command takes effect for all VLANs. If you specify
one or more VLANs, the command takes effect for the specified VLANs only.
To Next Page
Loading...
Need help?
General