357
Default level
2: System level
Parameters
scope-id: Specifies the value of the scope field, in the range of 3 to 15.
admin-local: Specifies the scope field value as admin-local, which has a scope value of 4.
global: Specifies the scope field value as global, which has a scope value of 14.
organization-local: Specifies the scope field value as organization-local, which has a scope value of 8.
site-local: Specifies the scope field value as site-local, which has a scope value of 5.
hash-length: Specifies the hash mask length of the IPv6 admin-scope zone indicated by the scope value,
in the range of 0 to 128. If you do not specify this argument, the corresponding global setting is used.
priority: Specifies the priority of the C-BSR in the IPv6 admin-scope zone indicated by the scope value,
in the range of 0 to 255. A larger value means a higher priority. If you do not specify this argument, the
corresponding global setting is used.
Description
Use c-bsr scope to configure the C-BSR in the IPv6 admin-scope zone.
Use undo c-bsr scope to remove the C-BSR configuration.
Related commands: c-bsr admin-scope, c-bsr hash-length, and c-bsr priority.
Examples
# Configure local device as the C-BSR of the IPv6 admin-scope zone with a scope value of 14 and set the
C-BSR priority to 10.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] c-bsr scope global priority 10
c-rp (IPv6 PIM view)
Syntax
c-rp ipv6-address [ { group-policy acl6-number | scope scope-id } | priority priority | holdtime
hold-interval | advertisement-interval adv-interval ] * [ bidir ]
undo c-rp ipv6-address
View
IPv6 PIM view
Default level
2: System level
Parameters
ipv6-address: Specifies the IPv6 address of the interface that will act as a C-RP.
acl6-number: Specifies a basic IPv6 ACL number, in the range of 2000 to 2999. This IPv6 ACL defines
a range of IPv6 multicast groups to which the C-RP is designated, rather than defining a filtering rule. Any
IPv6 multicast group range that matches the permit statement in the ACL is advertised as a group to
To Next Page
Loading...
Need help?
General