262
last-listener-query-interval (MLD-snooping view)
Syntax
last-listener-query-interval interval
undo last-listener-query-interval
View
MLD-snooping view
Default level
2: System level
Parameters
interval: Sets the MLD last-listener query interval in seconds. The value range is 1 to 5.
Description
Use last-listener-query-interval to configure the MLD last-listener query interval globally.
Use undo last-listener-query-interval to restore the default.
By default, the MLD last-listener query interval is 1 second.
The MLD last-listener query interval determines the interval for sending MLD multicast-address-specific
queries and the maximum response delay for MLD multicast-address-specific queries.
This command takes effect only in MLD snooping-enabled VLANs.
Related commands: mld-snooping last-listener-query-interval.
Examples
# Set the MLD last listener query interval to 3 seconds globally.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] last-listener-query-interval 3
max-response-time (MLD-snooping view)
Syntax
max-response-time interval
undo max-response-time
View
MLD-snooping view
Default level
2: System level
Parameters
interval: Specifies the maximum response delay for MLD general queries in seconds. The value ranges
from 1 to 25.
Description
Use max-response-time to configure the maximum response time for MLD general queries globally.
To Next Page
Loading...
Need help?
General