358
which the RP is designated, but the configuration that matches other statements, like deny, does not take
effect.
scope-id: Specifies the value of the scope field, in the range of 3 to 15.
priority: Specifies the priority of the C-RP, in the range of 0 to 255 and defaulting to 192. A larger value
means a lower priority.
hold-interval: Specifies the C-RP timeout time, in seconds. The value ranges from 1 to 65,535. If you do
not specify this argument, the corresponding global setting is used.
adv-interval: Specifies the C-RP-Adv interval in seconds, with an effective range of 1 to 65,535. If you do
not specify this argument, the corresponding global setting is used.
bidir: Configures the C-RP to provide services for multicast groups in the bidirectional PIM mode. If you
do not specify this argument, the C-RP provides services for multicast groups in the IPv6 PIM-SM mode.
Description
Use c-rp to configure the specified interface as a C-RP.
Use undo c-rp to remove the related C-RP configuration.
No C-RPs are configured by default.
You must enable IPv6 PIM-SM on the interface that you want to configure as a C-RP.
If you do not specify an IPv6 multicast group range for the C-RP, the C-RP provides services for all IPv6
multicast groups in the IPv6 non-scoped zone, or it provides services for IPv6 multicast groups in the IPv6
global admin-scope zone if IPv6 administrative scoping is configured.
To configure a device as a C-RP for multiple group ranges, you must include these group ranges in
multiple rules in the IPv6 ACL that corresponds to the group-policy keyword.
If you use this command repeatedly on the same interface, the last configuration takes effect.
Related commands: c-bsr.
Examples
# Configure the interface with the IPv6 address of 2001::1 to be a C-RP for IPv6 multicast group
FF0E:0:1391::/96, with a priority of 10.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] rule permit source ff0e:0:1391:: 96
[Sysname-acl6-basic-2000] quit
[Sysname] pim ipv6
[Sysname-pim6] c-rp 2001::1 group-policy 2000 priority 10
c-rp advertisement-interval (IPv6 PIM view)
Syntax
c-rp advertisement-interval interval
undo c-rp advertisement-interval
View
IPv6 PIM view
To Next Page
Loading...
Need help?
General