387
pim ipv6 hello-option holdtime
Syntax
pim ipv6 hello-option holdtime interval
undo pim ipv6 hello-option holdtime
View
Interface view
Default level
2: System level
Parameters
interval: IPv6 PIM neighbor timeout time in seconds, with an effective range of 1 to 65,535. A value of
65,535 makes the PIM neighbor always reachable.
Description
Use pim ipv6 hello-option holdtime to configure the PIM neighbor timeout time on the current interface.
Use undo pim ipv6 hello-option holdtime to restore the default.
By default, the IPv6 PIM neighbor timeout time is 105 seconds.
Related commands: hello-option holdtime.
Examples
# Set the IPv6 PIM neighbor timeout time to 120 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 hello-option holdtime 120
pim ipv6 hello-option lan-delay
Syntax
pim ipv6 hello-option lan-delay interval
undo pim ipv6 hello-option lan-delay
View
Interface view
Default level
2: System level
Parameters
interval: LAN-delay time in milliseconds, with an effective range of 1 to 32,767.
Description
Use pim ipv6 hello-option lan-delay to configure the LAN-delay time—namely, the time that the device
waits before it forwards a received prune message—on the current interface.
Use undo pim ipv6 hello-option lan-delay to restore the default.
By default, the LAN-delay time is 500 milliseconds.
To Next Page
Loading...
Need help?
General