398
By default, the router calculates the checksum based only on the header in the register message.
Related commands: register-policy and register-suppression-timeout.
Examples
# Configure the router to calculate the checksum based on the entire register message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] register-whole-checksum
reset pim ipv6 control-message counters
Syntax
reset pim ipv6 control-message counters [ interface interface-type interface-number ]
View
User view
Default level
1: Monitor level
Parameters
interface-type interface-number: Resets the IPv6 PIM control message counter on a particular interface. If
no interface is specified, this command clears statistics for IPv6 PIM control messages on all interfaces.
Description
Use reset pim ipv6 control-message counters to clear statistics for IPv6 PIM control messages.
Examples
# Clear statistics for IPv6 PIM control messages on all interfaces.
<Sysname> reset pim ipv6 control-message counters
source-lifetime (IPv6 PIM view)
Syntax
source-lifetime interval
undo source-lifetime
View
IPv6 PIM view
Default level
2: System level
Parameters
interval: IPv6 multicast source lifetime in seconds, with an effective range of 1 to 31,536,000.
Description
Use source-lifetime to configure the IPv6 multicast source lifetime.
Use undo source-lifetime to restore the default.
To Next Page
Loading...
Need help?
General