393
pim ipv6 timer graft-retry
Syntax
pim ipv6 timer graft-retry interval
undo pim ipv6 timer graft-retry
View
Interface view
Default level
2: System level
Parameters
interval: Graft retry period in seconds, with an effective range of 1 to 65,535.
Description
Use pim ipv6 timer graft-retry to configure the graft retry period.
Use undo pim ipv6 timer graft-retry to restore the default.
By default, the graft retry period is 3 seconds.
Examples
# Set the graft retry period to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 timer graft-retry 80
pim ipv6 timer hello
Syntax
pim ipv6 timer hello interval
undo pim ipv6 timer hello
View
Interface view
Default level
2: System level
Parameters
interval: Hello interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use pim ipv6 timer hello to configure the interval at which hello messages are sent on the current
interface.
Use undo pim ipv6 timer hello to restore the default.
By default, hello messages are sent at the interval of 30 seconds.
Related commands: timer hello.
To Next Page
Loading...
Need help?
General