HP 3600 v2 Series User Manual

285
undo report-aggregation
View
MLD-snooping view
Default level
2: System level
Parameters
None
Description
Use report-aggregation to enable MLD report suppression.
Use undo report-aggregation to disable MLD report suppression.
By default, MLD report suppression is enabled.
For the HP 3600 v2 EI switches, this command takes effect in both MLD snooping-enabled VLANs and
VLANs with MLD enabled on their VLAN interfaces.
For the HP 3600 v2 SI switches, this command takes effect in MLD snooping-enabled VLANs.
Examples
# Disable MLD report suppression.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] undo report-aggregation
reset mld-snooping group
Syntax
reset mld-snooping group { ipv6-group-address | all } [ vlan vlan-id ]
View
User view
Default level
2: System level
Parameters
ipv6-group-address: Specifies an IPv6 multicast group. The value range of ipv6-group-address is
FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), where x and y represent any
hexadecimal number between 0 and F, inclusive.
all: Specifies all IPv6 multicast groups.
vlan vlan-id: Specifies a VLAN. The value range of vlan-id is 1 to 4094.
Description
Use reset mld-snooping group to remove the dynamic group entries of a specified MLD snooping group
or all MLD snooping groups.
This command takes effect only in MLD snooping-enabled VLANs.
This command cannot remove the static group entries of MLD snooping groups.

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English